Nt10

※ Do not use lithium (Li-ion 16340) rechargeable batteries as they could damage the ※ Dimensions: 93mm (Length) x 25.3mm (Head) x 21.5mm (Body) light. When using rechargeable batteries ensure they do not exceed 3.2 volts as they Compact and Powerful: Our NT series CR123A lithium battery powered lights are
designed to meet the extreme demands of Law Enforcement and the Military but ※ Remove battery when stored for extended periods. priced to serve anyone that wishes to buy them for general outdoor use. ※ Included accessories: holster, lanyard, two spare o-rings, and a rubber switch boot ※ Replace and lubricate O-Rings as needed to maintain IPX-8 rating.
※ Use soft brush and soapy water to clean the body of the light.
Features:
The above-mentioned parameters are approximate and may vary between
※ Variable frequency strobe: easily accessed from any light mode flashlights, batteries and environments; Data was achieved using Duracell
Warranty Service
CR123A battery
Klarus guarantees this flashlight against defects in material and workmanship. ※ Intelligent memory function (memorizes the last used lighting mode) Flashlight products that are found to be defective under normal use within 2 years of ※ Super low mode offering extended runtime Operation
the proof of purchase date will be repaired or replaced without charge. This warranty ※ High-efficiency digitally regulated output - maintains constant brightness ※ To activate your flashlight, depress tail switch fully so that it clicks. To turn the does not cover damage caused by accident, unreasonable use or product alteration. flashlight off, depress tail switch fully so that it clicks. Failure to follow the general maintenance directions could result in damage to your flashlight that may not be covered by the Klarus warranty.
With the flashlight turned on, press side switch and then release immediately, the brightness mode will change: High--Low--Mid. Intelligent memory function will If this flashlight should prove defective, the product will be repaired or replaced, under memorizes the last used lighting mode. Hidden mode: twist the flashlight head counter the above terms. Please contact Klarus or your authorized Klarus retailer for warranty clockwise (loosen the head). Then using the side switch the output sequence will be: Specification:
Super Low—SOS--Beacon (No memory function for flashing modes) ※ Emitter: Cree XP-G R5 LED with a lifespan of 50,000 hours ※ Strobe access: Press and hold the side switch for 0.5 seconds on any lighting mode to access strobe. When in strobe mode, click side switch to return to previous ——Lighting mode: 230 lumens (1hrs) -> 13 lumens (30hrs) -> 120 lumens (2.8hrs) -> 8 lumens (50hrs) ※ Momentary activation: Soft press tail switch. (No click) ——Flashing modes: SOS(120 Lumen, 7.8hrs) -> Beacon (120 Lumens, 39hrs) -> Variable frequency strobe (230Lumens, 2hrs) Battery Replacement
Unscrew the tail of the flashlight and insert the battery with anode (+) side toward the ※ Battery: 1pc 3-volt CR123A lithium battery. light's head. Screw the tail back on to test. ◎ Tactical tail switch for power on and off with momentary activation Usage and Maintenance
◎ Side switch for adjusting brightness output ※ Do not shine light directly into eyes ◎ Rotate the flashlight head to access hidden modes (Super Low, SOS, Beacon) ※ Use only quality brand name batteries.
◎ Strobe access: Press and hold the side switch for 0.5 seconds in any mode ※ 9 lumen mode requires a voltage of 2.6v or less, A fresh battery will produce 13 lumens in Super low mode until voltage drops to 2.6v

Source: http://www.klaruslight.co.uk/product-manuals/KLARUS-manual-NT10.pdf